Tips for Maintaining Your Water Heater System


A hot water service is a crucial appliance in any Australian home. It provides the necessary hot water for showers, laundry, and other household needs. Neglecting your hot water service can lead to costly repairs or replacements, not to mention the inconvenience of going without hot water. Therefore, regular maintenance is necessary to keep your hot water service running efficiently and extend its lifespan. In this blog post, we’ll provide some tips for maintaining your water heater in Australia.


Regularly Drain and Flush Your Water Heater

In Australia, hard water is a common issue that can cause mineral build-up and sediment to accumulate in your hot water service over time. This build-up can lead to rust and corrosion, which can reduce the effectiveness of your hot water service. Therefore, it is important to regularly drain and flush your water heater to remove any sediment and mineral build-up. This process involves turning off the power or gas supply to your water heater, connecting a hose to the drain valve, and allowing the tank to empty completely. After the tank is drained, you should fill it up again and flush it out until the water runs clear. Regular flushing can also improve the efficiency of your hot water service by removing the sediment that can reduce its effectiveness.


 Check the Anode Rod

The anode rod is a component of your hot water service that attracts corrosive elements in the water to protect the tank from rusting. Over time, the anode rod will wear out and need to be replaced. Checking the anode rod should be a part of your hot water service maintenance routine. In Australia, it is important to check the anode rod every two years due to the hard water conditions. You can remove the anode rod from the top of the tank and check for any signs of wear or corrosion. If the rod is less than half an inch thick or is covered in calcium deposits, it’s time to replace it. Replacing the anode rod can extend the lifespan of your hot water service and prevent costly repairs.

Inspect the Pressure Relief Valve

The pressure relief valve is an essential safety feature of your hot water service. It prevents the tank from becoming over-pressurized, which can cause it to explode. Therefore, it is important to inspect the pressure relief valve regularly to ensure that it is functioning properly. To test the pressure relief valve, turn off the power or gas supply to the hot water service and open the valve by lifting the lever. You should hear a rush of air or water escaping. If there is no sound or water coming out, the valve may be faulty, and you should call a professional to replace it.


Maintain Proper Insulation

In Australia, hot water services are often located outside or in unheated areas of the house, such as the garage or basement. Therefore, it is important to maintain proper insulation to prevent heat loss and increase the efficiency of your hot water service. Insulation helps to keep the hot water inside the tank at the desired temperature, reducing the amount of energy required to heat the water. You can wrap your hot water service with an insulation blanket, which is readily available at most hardware stores.


In conclusion, taking care of your hot water service is vital to ensure the smooth functioning of this essential appliance in your home. Regular maintenance not only extends the lifespan of your hot water service but also helps in improving its efficiency, leading to reduced energy consumption and lower utility bills. Neglecting maintenance can lead to mineral build-up, rust, and corrosion, which can ultimately damage your hot water service and require expensive repairs or replacements. 


By following the maintenance tips mentioned in this blog, such as regularly flushing your water heater, checking the anode rod, inspecting the pressure relief valve, and maintaining proper insulation, you can keep your hot water service in good condition and avoid any unnecessary headaches or expenses. Remember, prevention is always better than cure, and regular maintenance is the key to preventing costly repairs or replacements in the future. So, take care of your hot water service, and it will take care of you and your household needs for years to come.

Contact Clearwater Plumbing for any of your hot water service needs.



Categorized as News

Call us today on 1300 616 202

or send an enquiry to have a reliable plumber in Geelong visit your home or commercial premises.

Contact Us